Subbases and Disconnect Switches
Wall Sleeves, Sleeve Adapter and Draink Kit
Wireless RF Energy Management
Raising the bar in PTAC Controls
Designed exclusively for Amana PTAC units, DigiSmart technology has dramatically raised the bar in PTAC controls. Your guests will appreciate its large, easy-to-read LED readout that allows them to check the temperature with a quick glance and, if desired, to change the setting to a specific temperature by pressing a button. The ability to select a precise temperature helps your guests avoid over-cooling their rooms, a situation that often occurs with knob-type controls, which are less precise.
What's more, the DigiSmart Control Board offers many programmable features and self-diagnostics that help facility personnel better manage the care and maintenance of the PTACs in their facility and allow management to better control operating costs. One of these features is a "setback" program that senses whether or not a unit has been touched within a specific window of time. If the unit has not been touched, the system then concludes that the room in which the PTAC is located is vacant and begins setting the temperature back in three successive steps, thereby saving energy.
The most significant breakthrough in the PTAC industry, is the new DigiSmart Wireless Energy Management Suite that helps ensure that you minimize energy used in cooling your guest rooms when your guests are not in the room.
Enhance Room Value, Gain Control and Start Saving 35% on PTAC Energy Costs!
There are three key pieces to the DigiSmart Wireless Energy Management Suite: a Wireless Antenna, a Remote-Mounted Thermostat, and a combination Motion Sensor/Door Switch. When installed withan Amana brand PTAC, the system works as follows.
(1) Plug in the DigiSmart Antenna.
Once a technician plugs this small antenna into the DigiSmart control board, the unit is ready to communicate with the Thermostat and the Motion Sensor/Door Switch. And as you install these amazing DigiSmart antennae in all of the PTACs in your facility, they will form a network and begin to talk to one another.
(2) Set and Mount the DigiSmart Remote-Mounted Thermostat.
Simply push a button inside the thermostat to link it to the PTAC and mount the thermostat on the wall.
(3) Set and Mount the DigiSmart Occupancy Control.
A simple push of a button will link this device to the PTAC. Then just mount the DigiSmart Motion Sensor/Door Switch above the door, and the Amana brand's proprietary software routines will begin working with this device to determine whether the room is occupied. While the guest is in the room, the PTAC maintains the selected temperature. When the guest is away, however, the energy management system sets the temperature back based on setback routines that you can determine yourself.
The new DigiSmart Wireless Energy Management Suite is an extremely valuable way for you to help control the energy used in your guest rooms, which can dramatically reduce your operating costs over time.
This air conditioner has an Energy Efficiency Rating of 10.3 and has an estimated yearly operating cost of $94.48.
The estimated yearly operating cost is based on the 2011 national average cost of $.1109 cents per kWh for electricity and an estimated number of operating hours of 750 hours. Your operating cost will depend on your utility rates and usage.
Unit without Electric Heater
CFM (Cool/Wet Coil) - High:
CFM (Cool/Wet Coil) - Low:
CFM (Dry Coil) - High:
CFM (Dry Coil) - Low:
Ventilated Air, CFM (Fan Only):
65 (Approximately 95 CFM with optional power vent kit. Actual vent CFM performance will vary due to application and installation conditions.)
Ventilated Air, CFM (Compressor & Fan):
6 (Approximately 95 CFM with optional power vent kit. Actual vent CFM performance will vary due to application and installation conditions.)
Electric Heat Performance
Nominal Heating @ 230V:
Nominal Heating @ 208V:
Nominal Heating @ 265V:
3,570 / 2,935
Min. Circuit Ampacity:
Electrical Specifications & Performance
11,700 / 11,500
Dimensions & Weight
Depth of Wall Sleeve:
Increased Dehumidification Capacity
Condensate Dispersion System
- Removes condensate from indoor cooling operation and evaporates it into the atmosphere through the condenser
- Prevents compressor short-cycling
30-Second Fan-Off Delay
Constant fan mode
- Easily removable filters are easy to maintain
- Filter dryer for sealed system refrigerant
Zero Floor Clearance
- Allows unit to be installed flush to a finished floor
- Blends into any room's color scheme and decor
7 5/8" Unit Front Depth
- One of the shallowest silhouettes in the industry today
Easy to Service with On-Board LED Diagnostics
Removable Condenser Shroud
- Allows easy access to enable regular cleaning of coils
Digismart Front Desk Control & Energy Management Software
7-Button Touch Pad
- Provides complete control to guests for in-room comfort while maintaining energy efficiency
Room Freeze Protection
- Is activated when the unit senses temperatures of 40°F or below
Digismart Wireless Remote Thermostat is Available
Remote Temperature Sensing for Guest Climate Control
Hidden Ventilation Control