Amana DigiSmart PTC123D35AR

Duct Extension Kit

Exterior Grilles

Miscellaneous Accessories

Remote Thermostats

Subbases and Disconnect Switches

Wall Sleeves, Sleeve Adapter and Drain Kit

Wired Energy Management Accessories

Wireless RF Energy Management Accessories

Add

2 Year Warranty for a Major Appliance Under $1,500

$36.99

Add

3 Year Warranty for a Major Appliance Under $1,500

$67.99

Add

5 Year Warranty for a Major Appliance Under $1,500

$124.99

The Amana brand Packaged Terminal Air Conditioner is designed for customer comfort and owner piece of mind. No other unit in the industry offers so many energy management features as standard. And DigiSmart PTACs come with all the accessories you expect including seacoast coils, options for hydronic heat and a full line of sleeves and grilles. Best of all the DigiSmart energy management system offers you the ability to reduce energy consumption by up to 35%.

With all this to offer, there is no need to settle for anything less than the Amana brand DigiSmart PTAC.

PTAC systems are single units that provide both heating and cooling operations from one product. This is different from the air conditioning systems used in most North American homes which use split systems. This name is derived from the fact that two components are required to complete the system; an indoor coil (inside the home) and an external condenser (outside the home).

Using electricity as its power source, the PTAC compressor pumps refrigerant through the system. The refrigerant attracts heat and moisture from indoors and then transfers it outdoors. Heat and moisture inside are removed when warm air passes over the cool indoor coil. The heat and humidity in the air are removed by the coil, thereby "cooling" the air indoors.

When the PTAC operates in the heating mode, the unit operates in reverse. The refrigerant is used to create a heated indoor coil. As air passes over the heated coil the heat is transferred to the air inside the room creating warm air.

Indoor comfort all year - PTACs can rapidly remove heat and moisture from indoor air. You simply set the units thermostat to the temperature that you desire and the unit automatically cools to that level. You can manually select fan speed or use the automatic fan speed setting. When you need the room to be heated you use the same basic settings. Just set the thermostat to the temperature you want and select the heating function.

Simple Installation - PTACs are easy to install because they come in standard sizes and shapes. Regardless of the heating and cooling load requirements, the unit is the same size. Since both the heating and cooling systems exist inside a single unit, installation is easier than the installation of a split system.

Independent Operation - Unlike split-system heating and cooling systems which condition whole buildings through the use of ductwork, PTACs cool and heat only the rooms or spaces where they are installed. This means you cool or heat only what you want with individual temperature control. With multiple PTACs installed, you can easily control indoor temperature on a room to room basis.

Dimensions & Weights
Overall Width:	42"
Chassis Width:	40"
Wall Sleeve Width:	42"
Overall Depth excl. Outdoor Grille:	21 1/2"
Wall Sleeve Depth:	14 1/8"
Overall Height:	16 1/16"
Net Weight:	105 lbs.
Shipping Weight:	120 lbs.
Power/Ratings
Voltage:	230/208
Capacity:	12,000/11,900 BTU/h
Amps:	5.0/5.3
Watts:	1,120/1,100
EER:	10.7
Unit without Electric Heater
Minimum Circuit Amps:	6.6
CFM (Cool/Wet Coil) - High:	310/300
CFM (Cool/Wet Coil) - Low:	240/230
CFM (Dry Coil) - High:	335/325
CFM (Dry Coil) - Low:	260/250
Ventilated Air (Fan Only):	70 CFM (Approx. 95 CFM with optional power vent kit)
Ventilated Air (Compressor & Fan):	70 CFM (Approx. 95 CFM with optional power vent kit)
Dehumidification:	3.3 Pints/Hr.
Electric Heat Performance (Primary Heat for PTC Models)
Voltage:	230/208 Volts
Electric Heater Size:	3.5/2.9 kW
No. of Stages:	1
Nominal Heating @ 230V:	12,000 BTU/h
Nominal Heating @ 208V:	9,900 BTU/h
Total Watts:	3,650/3,040
Total Amps:	15.8/14.5
Minimum Circuit Ampacity:	19.6
MOD:	20 Amps
Power Cord:	6-20P

• On-Board Energy Management System (EMS)
• Set-Back Mode
• The owner can determine amount of time unit is left 'untouched' (buttons not pushed) before the PTAC begins a set-back routine and new thermostat temperature takes effect.
• All set-back routines can be changed by owner.
• Maintenance Status
• Separate green LED indicator light to show if unit requires maintenance.
• Electronic Temperature Limits
• Owner can set separate cooling and heating temperature ranges and limit operation to one-degree increments, saving energy by preventing guests from over-cooling or over-heating.
• Enhanced Dehumidification Cooling Mode
• The unit can be set to lengthen cooling cycles while the room is occupied or unoccupied.
• This passes more air through the unit while the coil is below the dew point, increasing the amount of moisture removed.
• Unit Diagnostics
• When switched to diagnostics mode, the unit shows ten different self-diagnosis codes to help keep the unit running most efficiently.
• Freeze Protection
• when sensors show temperature of 40°F or below, the unit automatically activates the fan motor and the electric or hydronic heat to help prevent burst water pipes or broken fixtures caused by freezing temperatures.
• Extended Heating with the Heat-Pump
• Heat pump models will operate in heat-pump mode with external temperatures as low 24°F to provide additional energy savings.
• 30-Second Fan-Off Delay
• The fan continues to run for 30 seconds after the compressor has stopped or after electric heat has been turned off.
• This improves efficiency by dispersing the cooled or heated air still on the coil into the room.
• Amana Brand PTACS are:
• Energy Efficient:
• Amana brand PTACs offer EER up to 12.8 and on heat pumps COP as high as 3.6
• Easy to Clean:
• Inside the room, the removable pullout polymer filter is easy to clean and is ready for an optional activated charcoal filter to remove odors
• Outside, the removable condenser shroud means east access for coil cleaning, helping to maintain unit performance
• Easy to Use:
• One touch digital controls are simple and easy to use
• Maximize Room Space:
• Slim 7 3/8" in-room depth and ability to install with zero floor
• Low Temperature Operation:
• Heat pump operates as low as 24° and units come with "Freeze Protection" standard, running fan and heat when temperature dips below 40°
• Automatic Energy Heat:
• No more "No Heat" complaints in the middle of the night as heat pumps switch on electric heater if heating load greater than unit capacity.
• Full line of accessories including:
• DigiSmart suite of Peripherals - Wireless Thermostat; Wireless Occupancy Sensor; Network Controller
• Wall Sleeves in Stonewood (standard) or custom colors by order
• Grilles in aluminum (stamped and extruded) or plastic in Stonewood (standard) or custom colors by order
• Wired Thermostats
• DigiSmart Suite of products
• Automatic Network Setup
• The DigiSmart RF network automatically configures and heals itself.
• No need to log unit on or off the network.
• High-Capacity Network
• DigiSmart runs independently on each PTAC or up to 170 units in a single network installation
• Set-Back Mode
• The owner can determine amount of time unit is left 'untouched' (buttons not pushed) before the PTAC begins a set-back routine and new thermostat temperature takes effect.
• All set-back routines can be changed by owner.
• Electronic Temperature Limits
• Owner can set separate cooling and heating temperature ranges and limit operation to one degree increments, saving energy by preventing guests from over-cooling or over-heating.
• Enhanced Dehumidification Cooling Mode
• The unit can be set to lengthen cooling cycles while the room is occupied or unoccupied.
• This passes more air through the unit while the coil is below the dew point, increasing the amount of moisture removed.
• Maintenance Status
• Separate green LED indicator light to show if unit requires Maintenance at the unit level.
• Network interface shows status of each PTAC and peripheral (thermostat or sensor)
• Unit Diagnostics
• When switched to diagnostics mode, the unit shows ten different self-diagnosis codes to help keep the unit running most efficiently.
• Email Notification
• Once linked to a PC, the DigiSmart network can automatically send an e-mail to notify a property of maintenance issues.
• Energy Management System (EMS) software
• Is written in 'flash' memory in the control board and not 'hard coded'.
• That means EMS software can be updated at the PTAC or through the DigiSmart network without needed to visit each unit.

Installation and Owners Manual

Quick Specs/Dimensions